Get free quotes
Kilsyth 3137Climate zone 7 · AusNet Services (electricity)

Air conditioning
in Kilsyth

A 30 square metre living room in Kilsyth needs about 4.13kW, against 3.11kW for the same room in Portland, because Kilsyth peaks at 35.1°C where Portland hits 29.1°C. Installed prices here run $1,450–$3,700 for splits.

Get Kilsyth quotes

Up to 3 licensed installers who work your postcode. Free, no obligation.

What do you need quoted?

✓ Licensed & insured · ✓ Free, no-obligation quotes

Daikin · Mitsubishi · Fujitsu · Panasonic · LG + more

Why Kilsyth is different

Sizing advice written for "Melbourne" is written for an average that barely exists. Kilsyth accumulates 24.6 cooling degree days a year and clears 35°C about 11 days. Portland, across Melbourne, accumulates 10.1 and clears 35°C about 2.5 days — roughly 2 times the cooling demand. That is why the same room needs a different size unit depending which suburb it sits in, and why a number quoted for the metro average will be wrong for most addresses in it.

What size you need in Kilsyth

RoomApprox sizeCooling neededUnit to look for
Bedroom 12m² 1.65kW 2kW
Large bedroom or study 18m² 2.48kW 2.5kW
Small living area 25m² 3.44kW 3.5kW
Living room 30m² 4.13kW 4.2kW
Open-plan living and dining 45m² 6.19kW 6kW
Large open plan 60m² 8.26kW 8kW

Sizing follows the design criterion AIRAH uses in its FairAir calculator: the 3pm outdoor temperature exceeded on no more than 10 days a year. We compute that figure for each suburb from Bureau of Meteorology daily records, then split the cooling load into a component that scales with how far the design temperature sits above 24C and a component from sun and internal heat that barely varies by location. That 50/50 split is our assumption, not AIRAH's. Treat the result as a starting point for a quote, not a substitute for an installer measuring your rooms.

What it costs to run here

Kilsyth sits in the AusNet Services (electricity) network area, where a residential flat rate currently runs about 31.98c per kilowatt hour (AGL Residential Standing Offer). On that rate, a typical 3.5kW split system used normally costs roughly $36 a year in cooling, against about $6 for the identical unit in Portland.

That figure starts from the appliance's registered energy rating data, then scales it by Kilsyth's own cooling degree days against the reference site the rating uses (Canberra Airport (070351), 33 degree days). Without that adjustment every suburb in the zone would show an identical number, which would tell you nothing.

Watch the peak window.

On a time-of-use plan in this network, electricity between 15:00 to 21:00 costs about 46.82c against 23.99c off-peak. Cooling the house hard through that window is where summer bills actually get away from people. Pre-cooling before it starts costs noticeably less.

Local factors

What changes a quote in Kilsyth

You probably need less than you think

Kilsyth accumulates only 24.6 cooling degree days a year and clears 35°C about 11 days. Oversizing is the common and expensive mistake here: too much capacity short-cycles, dehumidifies poorly and costs more upfront and to run. If an installer quotes a size up without measuring the room, ask them to justify it.

Winter matters as much as summer

With 1690 heating degree days and July mornings averaging 4°C, a reverse-cycle system in Kilsyth earns its keep for heating at least as much as cooling. Ask for the heating output at low ambient temperature rather than the nominal kW, because that figure is what determines whether it copes on the coldest mornings.

Ducted is genuinely viable here

86.8% of Kilsyth dwellings are separate houses, most with accessible roof space, which makes ducted a real option rather than a stretch. The check that matters is roof cavity height and insulation condition, and any installer can confirm both in a five-minute inspection before quoting.

The peak window costs real money here

On a AusNet Services (electricity) time-of-use plan, electricity runs about 46.82 cents during the peak window (15:00 to 21:00) against 23.99 cents off-peak, close to double. Cooling the house hard through that window is where summer bills get away from people in Kilsyth. Pre-cooling before it starts costs noticeably less for the same comfort.

Installed prices

SystemInstalled priceSuits
Small split (2.5kW)$1,450–$2,300Bedrooms and studies
Large split (5-7kW)$2,400–$3,700Living areas
Ducted, whole home$8,000–$16,000Houses with roof access

Melbourne pricing. See the full Melbourne cost guide for a breakdown by job, or the Victoria rebate guide for discounts that come off these figures.

About Kilsyth

Around 12,528 people live in Kilsyth (estimated for 2025), across roughly 5,513 occupied dwellings. The housing mix is 1.1% apartments, 86.8% separate houses and 12.2% semi-detached or townhouses, which is what drives most of the practical differences in getting a system installed here.

Nearby suburbs

Climate, network tariffs and housing stock shift across a metro, so the sizing and running costs on these pages differ from Kilsyth's.

Sources and data

Based on Australian Bureau of Statistics data. Source: ABS, Census of Population and Housing 2021 and Regional population 2024-25, licensed under CC BY 4.0. Climate data: Bureau of Meteorology, licensed under CC BY 4.0. Climate zones: Australian Building Codes Board. Tariffs: Consumer Data Right energy plan data. Appliance energy data: energyrating.gov.au (E3 Program).

Population is an estimate derived from the 2021 Census count scaled by regional growth to 2025, not an official count. Climate figures come from COLDSTREAM (086383). The nearest qualifying station is FERNY CREEK (086266) at 8.5 km, but it is 384 m higher; its record is shorter or less complete (15.5 yr, 98%). COLDSTREAM (086383) is 12.2 km away, 41.9 km from the open coast against the suburb's 30.3 km, at 83 m against the suburb's 129 m. Stations are ranked on distance plus penalties for differing coastal exposure, elevation, NCC climate zone, record length and marine (sand-spit or island) siting.

Air conditioning in Kilsyth: questions

What size air conditioner do I need in Kilsyth?
For a typical 30 square metre living room in Kilsyth, about 4.13kW, which in practice means a 4.2kW unit. Bedrooms usually land around 2kW. That comes from Kilsyth's design temperature of 35.1°C, against 29.1°C in Portland, which is why the same room needs a different size in each. Any installer should still measure the room, since orientation, glazing and insulation move the answer.
What does it cost to run air conditioning in Kilsyth?
Roughly $36 a year in cooling for a typical 3.5kW split used normally, on AusNet Services (electricity) network rates of about 31.98 cents a kilowatt hour. That figure starts from the appliance's registered energy rating and is then scaled by Kilsyth's own cooling degree days against the reference site the rating uses, because without that adjustment every suburb in the zone would show an identical number. If you are on a time-of-use plan, the peak window is where summer bills actually get away from people.
Can I get ducted air conditioning in Kilsyth?
Usually yes. 86.8% of Kilsyth dwellings are separate houses, and most have the roof access ducted needs. The practical checks are cavity height, insulation condition and whether your switchboard can carry the load, all of which an installer confirms on a short site visit before quoting.
When is the cheapest time to install in Kilsyth?
The shoulder seasons, and in Kilsyth that means autumn or early spring. Demand here peaks twice, for cooling in summer and heating in winter, so the quiet windows sit between them. Quoting in a quiet window gets sharper prices and avoids the queue that forms after the first extreme day of either season.

Ready for Kilsyth quotes?

Up to 3 licensed installers who work your postcode, one written price each.

✓ Licensed & insured · ✓ Free, no-obligation quotes