Air conditioning
in Condell Park
A 30 square metre living room in Condell Park needs about 4.2kW, against 3.15kW for the same room in Kiama, because Condell Park peaks at 35.5°C where Kiama hits 29.3°C. Installed prices here run $1,350–$3,500 for splits.
Get Condell Park quotes
Up to 3 licensed installers who work your postcode. Free, no obligation.
Why Condell Park is different
Sizing advice written for "Sydney" is written for an average that barely exists. Condell Park accumulates 98.4 cooling degree days a year and clears 35°C about 12 days. Kiama, across Sydney, accumulates 21.5 and clears 35°C about 1.8 days — roughly 5 times the cooling demand. That is why the same room needs a different size unit depending which suburb it sits in, and why a number quoted for the metro average will be wrong for most addresses in it.
What size you need in Condell Park
| Room | Approx size | Cooling needed | Unit to look for |
|---|---|---|---|
| Bedroom | 12m² | 1.68kW | 2kW |
| Large bedroom or study | 18m² | 2.52kW | 2.5kW |
| Small living area | 25m² | 3.5kW | 3.5kW |
| Living room | 30m² | 4.2kW | 4.2kW |
| Open-plan living and dining | 45m² | 6.29kW | 6kW |
| Large open plan | 60m² | 8.39kW | 8kW |
Sizing follows the design criterion AIRAH uses in its FairAir calculator: the 3pm outdoor temperature exceeded on no more than 10 days a year. We compute that figure for each suburb from Bureau of Meteorology daily records, then split the cooling load into a component that scales with how far the design temperature sits above 24C and a component from sun and internal heat that barely varies by location. That 50/50 split is our assumption, not AIRAH's. Treat the result as a starting point for a quote, not a substitute for an installer measuring your rooms.
What it costs to run here
Condell Park sits in the Ausgrid network area, where a residential flat rate currently runs about 30.12c per kilowatt hour (ENGIE NSW ENGIE Standing elec). On that rate, a typical 3.5kW split system used normally costs roughly $63 a year in cooling, against about $14 for the identical unit in Kiama.
That figure starts from the appliance's registered energy rating data, then scales it by Condell Park's own cooling degree days against the reference site the rating uses (Richmond RAAF (067105), 113 degree days). Without that adjustment every suburb in the zone would show an identical number, which would tell you nothing.
On a time-of-use plan in this network, electricity between 15:00 to 20:59 costs about 54.72c against 21.85c off-peak. Cooling the house hard through that window is where summer bills actually get away from people. Pre-cooling before it starts costs noticeably less.
What changes a quote in Condell Park
44.8% of Condell Park homes are apartments
That changes the job more than the climate does. Most of that is three storeys or higher, so the owners corporation almost certainly has rules about condenser placement and noise. Expect to need owners corporation approval before anything is mounted on a common wall, and allow two to six weeks for it on top of the install lead time. Start the paperwork before you book the installer, because approval is the single most common cause of a delayed job in apartment suburbs.
You probably need less than you think
Condell Park accumulates only 98.4 cooling degree days a year and clears 35°C about 12 days. Oversizing is the common and expensive mistake here: too much capacity short-cycles, dehumidifies poorly and costs more upfront and to run. If an installer quotes a size up without measuring the room, ask them to justify it.
The peak window costs real money here
On a Ausgrid time-of-use plan, electricity runs about 54.72 cents during the peak window (15:00 to 20:59) against 21.85 cents off-peak, close to double. Cooling the house hard through that window is where summer bills get away from people in Condell Park. Pre-cooling before it starts costs noticeably less for the same comfort.
Installed prices
| System | Installed price | Suits |
|---|---|---|
| Small split (2.5kW) | $1,350–$2,000 | Bedrooms and studies |
| Large split (5-7kW) | $2,100–$3,500 | Living areas |
| Ducted, whole home | $6,500–$12,000 | Houses with roof access |
Sydney pricing. See the full Sydney cost guide for a breakdown by job, or the New South Wales rebate guide for discounts that come off these figures.
About Condell Park
Around 13,857 people live in Condell Park (estimated for 2025), across roughly 14,480 occupied dwellings. The housing mix is 44.8% apartments, 38.8% separate houses and 15.2% semi-detached or townhouses, which is what drives most of the practical differences in getting a system installed here.
Nearby suburbs
Climate, network tariffs and housing stock shift across a metro, so the sizing and running costs on these pages differ from Condell Park's.
Sources and data
- ABS Census 2021, dwelling structure and medians by postcode
- ABS Regional population 2024-25 (population estimate basis)
- Bureau of Meteorology, Climate Data Online
- Australian Building Codes Board climate zone map
- AIRAH FairAir cooling calculator (design condition methodology)
- Consumer Data Right energy plan data (network and tariffs)
- energyrating.gov.au product database (zoned energy rating data)
Based on Australian Bureau of Statistics data. Source: ABS, Census of Population and Housing 2021 and Regional population 2024-25, licensed under CC BY 4.0. Climate data: Bureau of Meteorology, licensed under CC BY 4.0. Climate zones: Australian Building Codes Board. Tariffs: Consumer Data Right energy plan data. Appliance energy data: energyrating.gov.au (E3 Program).
Population is an estimate derived from the 2021 Census count scaled by regional growth to 2025, not an official count. Climate figures come from BANKSTOWN AIRPORT AWS (066137). Nearest qualifying station (still reporting, 58.1 yr of record, 99% complete). BANKSTOWN AIRPORT AWS (066137) is 2.6 km away, 21.5 km from the open coast against the suburb's 19.2 km, at 7 m against the suburb's 52 m. Stations are ranked on distance plus penalties for differing coastal exposure, elevation, NCC climate zone, record length and marine (sand-spit or island) siting.